Compression ToolAluminum Compression Tool for Mini RG59, RG59 and RG6 Fixed Pin Connectors

• Use the appropriate ¼ x ¼ cable strip tool for the cable being terminated.
• Prep the cable and install the connector onto the cable per connector installation instructions
• Insert the connector into the plunger tip and push the cable down through the 360 degree connector support dogs
• Start to close the handles of the tool together
• As the handles close, the plunger slides toward the dogs
• When the handles are fully closed together, the connector has been terminated
• Open handles to remove the connector
• Back the connector away from the plunger slot and grasping the cable behind the connector, lift the assembly out of the tool

NOTE: The compression throw distance is set at the factory. A hex lock nut keeps the tool calibrated over long periods of use. Field calibration, if necessary, is quick and easy. We advise periodic use of 3 in 1 oil on the plunger only.

California Proposition 65

PVC-coated Products; PVC-coated Wires and Cables

WARNING: This product can expose you to chemicals including DINP and/or DEHP, which are known to the state of California to cause cancer and birth defects or other reproductive harm. For more information go to or our information page: California Proposition 65.

Forget Your Password ?

You have no items in your cart. Start Shopping